The 802.11ac standard can achieve maximum data rates of up to 1.3 Gbps under optimal conditions.

Fiber optics can support WAN connections over distances greater than 100 km, making them suitable for long-range communication.

The maximum hop count for RIP is 15; a hop count of 16 is considered unreachable.

The maximum length of a standard Ethernet cable (Cat 5e or Cat 6) is 100 meters for effective WAN connections.

The maximum length of a TCP segment is 65,535 bytes, which includes both the header and the data.

SQL Server 2000 allows a maximum of 1024 columns in a table.

A Class C network with a default subnet mask of 255.255.255.0 can be subnetted into 8 subnets by borrowing 3 bits from the host portion.

IPv6 can theoretically support approximately 340 undecillion unique addresses due to its 128-bit address space.

The 802.1Q standard allows for a maximum of 4096 VLANs to be created on a switch.

The 802.1Q standard allows for the creation of up to 4096 VLANs, as it uses a 12-bit VLAN ID.

The maximum output current of a standard 555 timer is typically around 20 mA.

A typical Wi-Fi network can reach up to 100 meters in open space, although this can vary based on environmental factors and the specific technology used.

The maximum size of a SQL Server 2000 database is 32 GB.

A single-layer DVD has a maximum theoretical capacity of 4.7 GB.

The multicast address range in IPv6 is defined as FF00::/8, which is used for multicast communication.

The Nyquist theorem states that to avoid aliasing, a signal must be sampled at least twice its maximum frequency.

The octal representation of decimal 8 is 10.

An ideal operational amplifier has infinite output impedance, allowing it to drive loads without affecting the output voltage.

11 + 01 = 100 in binary, which is 4 in decimal.

After three clock pulses, a 2-bit binary counter will output 10 (which is 2 in decimal).

An AND gate outputs high (1) only when both inputs are high (1).

A 2-input AND gate outputs 1 (true) when both inputs are true.

A NAND gate outputs high (1) when at least one input is low (0).

A 2-input NOR gate outputs 0 when at least one of its inputs is high; it only outputs 1 when both inputs are low.

A NOR gate outputs high (1) only when both inputs are low (0).

An OR gate outputs high (1) if at least one input is high (1).

An XOR gate outputs low (0) when both inputs are the same (either both 0 or both 1).

If the select line is 0, the output of the 2-to-1 multiplexer will be the value of input A, which is 0.

After 5 clock pulses, a 3-bit counter will output 101 in binary.

A 3-input XOR gate outputs high (1) if an odd number of inputs are high; with all inputs high, it outputs low (0).